Onicon System-10 P1 Instrukcja Użytkownika Pobierz pdf (Strona 25)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]

System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 25

3.3.5 Network Signal Connections

P1 serial output connections are connected to terminal T1 with the supplied plug as

shown. Do not exceed 4.4 in-lb (0.5 Nm) of torque when tightening.

CAUTION

Only qualied service personnel should make connections between the System 10-P1 BTU

Meter and the user’s external equipment. ONICON assumes no responsibility for damage caused

to the external equipment as a result of an improper installation.

RIGHT SIDE VIEW

(+)

(-)

20038-__ REV C

L1 N Not Used

CAUTION

Incoming and outgoing RS485 cable shield wires should be connected together, but must not be

connected to the System-10.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

Brak uwag

Onicon System-10 P1 Instrukcja Użytkownika Strona 25